Garage Door Torsion Spring Replacement

Commonly, there are two types of springs used on the overhead garage doors. These heavy, long, and metal springs are attached to the upper part of the garage door. They are commonly known as side-mounted or extension springs.

Another type of springs that are connected to a metal place that is placed at the center-right above the garage door opening and parallel to the surface of the garage door frame is known as “torsion springs”. These springs work using the basic principle of twisting with the help of cables that are connected to each side of the garage door on the lower panel. When it comes to replacing the broken garage door springs, you can do it on your own but if you don’t know the procedure, it is good to consult a professional garage door expert. Are you looking for reliable and certified garage door services for your home, https://fairfieldgaragedoor.com/garage-door-springs/ Visit Here Right Now!!

It is also important to remember here that conducting a DIY garage door spring replacement job can be dangerous if it is not handled with proper precautions because of the high tension imposed on the springs. You will have to follow all the safety measurements because you could close your eyes, hand, fingers, limbs, or even life.

This is why; intelligent individuals will leave this project to a professional garage door contractor. Before doing the spring replacement, release the tension from the old spring placement. Never ever touch the cable drums. It is good to use a screwdriver to wind off or wind up the garage door springs. First of all, insert a bar that is well-fitting into the winding core before doing anything with setscrews. Be careful and don’t use a box wrench or a socket for the setscrew. Place the bar in the cone for replacing the springs. Don’t touch the brackets while wounding the springs.

The procedure to replace the garage door springs:

Stop the power supply and disconnect the power cord of the garage door opener. In the traditional or older model of the opener, you will have to remove the fuse or flip the circuit breaker. It is also important to buy the right torsion springs to replace the damaged ones. Evaluate the type, size, and dimensions of the new spring. It is advised that avoid grabbing the torsion springs or touching the winding cones.

Mark the end of each shaft to maintain the balance of the garage door after the new spring installation. Wind off the other unbroken torsion spring and then remove the screws that are securing the cones to the mounting brackets. In the next step, replace, replace, and reinstall the required hardware. Windup the new springs properly. Check the garage door to maintain its balance. Apply any high-quality lubricant to minimize the chances of friction. Reconnect the garage door opener to see if it functions.