Tips and Tricks for Garage Door Repair

The overhead garage door regardless of whether it swings up in a single solid piece or rolls in multiple sections works with the aid of the garage door springs. The garage door runs on metal tracks that are placed on the walls of garage. A power spring system is used to provide power to lift it up and lower. Sturdy rollers are used to move the garage door on the tracks. If the garage door is showing hard or rough operations, it needs to be fixed quickly. Simple garage door problems can be fairly easy to handle while professional Arlington, TX garage door repair services should be called for the complex problems. Following are the helpful tips and tricks to get your project started.

Start your project by inspecting the metal tracks of your garage door. Have a look at the mounting brackets to see if they are loose. If you found any loose parts, you should tighten the screws and bolts to make the mounting brackets secure. Inspect the garage door by keeping it closed to find out the crimps, dents, or flat spots. If damages are found, pound the dented area with the help of a plastic hammer or rubber mallet. If the garage door panels or tracks are damaged badly, they should be replaced.

Next, inspect the garage door tracks with the help of level to make sure that they are aligned correctly. The horizontal tracks should slant slightly the position in a downward direction. In the case of roll-up garage doors, the vertical tracks should be plumb correctly. Metal tracks must be placed at the same height on both walls. In case the tracks do not appear aligned properly, you just need to loosen the screws that holding the mounting brackets and tap the tracks to their original position. Recheck the alignment of tracks with the help of level to ensure that their position is correct and then tightened the screws once again.

A good way to avoid the problems is to regularly clean the garage door tracks. You can use any mild household cleaner in order to remove the dirty and greasy formations. After cleaning the rollers and tracks, wipe down them properly to make them dry. You should lubricate all the moving components using powdered graphite and silicone spray. Make sure not to forget the rollers and pulleys in the system of the garage door to make them lubricated. Make sure that every part of the garage door should be cleaned and lubricated accordingly.

Inspect the garage door to find out the loose hardware in the mechanism and tightened them as required. For the swing-up garage door models, check the mounting plates where springs are installed to ensure that the screws are tightened properly. Pay attention to hinges that hold the sections together, tighten and replace them accordingly. Check the garage door opener to make sure that it is plugged in properly to get enough power supply.

Take a look at the springs to make sure that they are adjusted properly. On the swing-up garage doors, the springs are hooked into holes or notches. When a tension adjustment is needed, shift the spring hook into the next notch or hole. On the roll-up garage door models, the springs are controlled through strong metal cables and a simple pulley system. To adjust the tension, pull the cable further through the plate above the garage door and knot the end to maintain the tension. Garage door springs can be dangerous to handle, they should be left to professional garage door experts.